Would value any comments about this before I go poking around in my X1000.
I read about the hack. I think before I go hacking my X1000 I'll buy the software from AmigaKit to get hardware video playback on my Radeon HD card. So far I've been satified with the 3D permance of my ASUS 2G Radeon HD 7550 card. I say this even having already purchased an RX card which was targeted to go in a Tabor when they became available.
My purchased RX Card needs less space, power and is quiter. Hope that A-Eon/AmigaKit does not now believe that a Firmware Update is no longer necessary. But probably no one would come anyway...
Boot picture - yes Workbench - not really (wrong colors and crashing hard) Probably need to turn off everything beforehand (WBStartup/suer-startup) Unfortunately the early startup menu doesn't work (both mouse buttons pressed does nothing)
It doesn't seem to know what DDC is either :-/ Quote:
RadeonRX (2): Identified the chipset as: POLARIS11####################] 100 % RadeonRX (2): Graphics card name is: Radeon RX Polaris11 RadeonRX (2): If - and only if - your card does not work or does not work optimally please submit a bug report at: http://www.amiga.org/developer/bugreports Remember to include the driver version, and the following card details: 0x67FF:0x1002:0x0B04: <name of board> and *please* describe the problems you are seeing in detail. graphics.library AltiVec/VMX enabled graphics.library PA6T optimizations enabled RadeonRX (0): RadeonRX.chip 2.11 (26.1.2022) RadeonRX (2): Identified the chipset as: POLARIS11 RadeonRX (2): Graphics card name is: Radeon RX Polaris11 RadeonRX (2): If - and only if - your card does not work or does not work optimally please submit a bug report at: http://www.amiga.org/developer/bugreports Remember to include the driver version, and the following card details: 0x67FF:0x1002:0x0B04: <name of board> and *please* describe the problems you are seeing in detail. gfx PA6T DMA enabled sb600sata.device 53.22 (28.6.2017)
Looking good. Would you please share here the exact syntax of the command you entered in CFE to get the startup env to autoboot?
I tried goos command from os4welt, it reboots the machine with autoboot, but the change does not change permanently. I tried the setenv -p which didn’t seem to work.