x1000 onboard NIC power led question

@All
Find out that on my x1000, when i connect router to the onboard NIC and then power on machine, then the leds both on router and on the NIC are green. All fine. Then, if i do "reset" by reset button on tower, they go to offline, and never come up even after OS4 loads up again. So , to make link again to work, i had to do exactly power off / power on.

Can somebody confirm if it only my x1000 acts like this, or all of them ?

Thanks!

@kas1e

I tested, and the lights always start to flicker. On the router it is green when I connect to the internal ethernet port, while it is orange if I connect the cable to the Realtek 8139 ethernet card. The router senses automatically the connection speed. 1000Mbit = green 10/100Mbit = orange.

Test:

1. disconnect eth-cable from RLT8139
2. connected to internal X1000 ethernet port
-> internal LEDs of X1000 ethernet port flicker
3. pressed "reset" button on X1000 case
4. Waited for AmigaOS4.1 FEu3 to fully boot
-> internal LEDs of X1000 ethernet port flicker

New test:
1. Turned off X1000
2. waited 1 minute
3. verified ETH-cable connected to X1000 port
4. boot AmigaOS
-> LEDs flicker
5. reset of OS via software (Workbench menu)
6. Waited OS to fully boot
-> LEDs flicker
7. reset system via software (Workbench menu)
8. Waited for OS to fully boot
-> LEDs flicker
9. Pressed Reset button on case
10. Waited for OS to fully boot
-> Leds flicker.

Maybe it is because I have RTL-8139 card installed?

However, I am not a lucky one to have driver for the internal X1000 ethernet device. Never released to the public as far as I know.

So even if the lights flicker (modem and internal LEDs on X1000) I can not use the port. I tried to manually select pa6t_eth.device in internet wizard, but it can not open device. (error sound and does not let me "continue" set up wizard)

Hope this helps your quest.