Quite a regular
Joined: 2006/11/27 17:23 Last Login
: 2020/4/12 12:04
Group:
Registered Users
|
Hi,
First thing - support questions are best emailing me directly - I only just noticed this thread had been updated.
The current drivers will give a read error on block 0 if the drive isn't connected. Are you absolutely sure the Catweasel is connected correctly?
First, check your prefs are set correctly by running the Catweasel preferences file. Make sure your drive is set to the correct type and in the correct place (i.e. Unit 0 regular PC 3.5" drive is the normal configuration, of a standard floppy after the twist in the cable).
Once that is done, check the Catweasel is talking to the drive. Easiest way to do this is run SuperDiskImage, and set the start and end track to about 30 or so. Then put in a disk, put a random filename in the Filename box (such as "ram:test.img") and tell it to read. You should see the drive start up, the light go on, and you should hear it seek to track 30 or whatever. If you don't - your CW either isn't recognised, or it's not finding the drive. Check all your connections (especially the PCI connector). I can't remember if the current public version has debug info. Find out by running Sashimi and see if it gives debugging information.
Best thing is to email me (see my sig) then we should get it sorted out.
|