Joined: 2006/12/19 23:09 Last Login
: 2019/7/3 22:24
From Westhall, Suffolk, UK
Group:
Registered Users
|
@328gts
I don't understand the question really mate, surely you push the pins through the board and then solder each one with some solder and a standard iron?
If you can't push the pins through the board,then it is likely the board or the pins need removing of the solder that was on there previously.
Looking at the A1200 board, the IDE connector is not surface mounted, so the job /should/ be a doddle.
|