AmigaOS 4.1FE Update 3 resolution setup problem [Solved]

Hi guys,
I am setting up a "new" ssd for my Sam440ep to show at Pianeta Amiga 2026. I did a fresh installation of Amiga OS 4.1FE up to Update 3. Everything is fine but I have problem to setup a resolution of 320x240 (using VGA not DVI). I also checked and then copied my old Radeon monitor from my old (but still current setup) AOS4.1FEU1 (with Enancher Software for Sam440 Edition) but it still doesn't work.. that's strange because if I connect my old hd with the 320x240 resolution it works, but in this new installation, it doesn't... My only guess is that the Enancher Software for the Sam440 (light version available back in the days) changed something in the monitor setup but I am not sure about and honestly I don't remember what I did back in the days to make it work.. Do you have any idea to help me and figure it out the problem? Obviously the monitor is the same
Thanks a lot

I don't know if it's possible on Sam440,
what about to clone your old HD over the
new SSD? Maybe you can do it on another computer.

P.S. maybe i'll see you at Pianeta Amiga :)

IIRC "new" radeon HD/RX cards min resolution is 640x480, so look if you have P96 settings and is there where you set a 320x240 but on a 640x480 screen.

@jabirulo

The "problem" is the graphics.library.kmod. So I copied the library from the update 2 over the one included in the update 3 and my Radeon M9 of Sam440ep can, now, display the 320x240 resolution. (I need that resolution for the emulation of old system like megadrive,snes, neogeo and so on..)

@pvanni

yes, on amiga, you can clone the hard drive just copying the content of the old one over the new one. But in this case I wanted to create a fresh and clean installation instead of having a "mess" hd LOL!