Problem using Sil 3132 Sata2 controller with X5000

I once plugged in a USB2 card into my X1000. It showed up on the PCI bus but Ranger reported it as something different than expected. Maybe as storage and not USB. I recall posting something about the details and seemed to get an angry response back. Which I thought was rather strange as I did recall the same card plugged into my XE came up in Ranger as being a standard USB card. The same software Ranger reported the same card as being different in my X1000.

Same card. Same software. Different machine. Gave a different hardware info. No explanation as to how this would happen if the hardware should be hardwired but different firmware used in this case.

I haven't had any such problems with the X1000. What version of CFE is installed on your X1000?