Looking forward to the show! I wasn't sure I was going to be able to make it.. in fact, it was looking bad.. but I will now be there!

-Slygon

@nbache

Thanks! I am also replacing my hard drive.. old one is starting to make noise.. I am sure it will fail eventually... so just trying to figure out the best, and most efficient way to get all the latest, and correct drivers.

Thanks!

-Eric

@kas1e

This is all fantastic information!

Quick question.. based on the guide, and the comments, I just want to make sure I have it all figured out... I am thinking about replacing my big R9 270X card with something smaller and a bit newer... So..

If I buy an RX 550, and do a completely clean install, should this work? (I have an X5000)

1. Install clean AmigaOS 4.1FE (X5000 version)
2. Install AmigaOS 4.1 FE Update 2.
3. Install Enhancer 2.2 (I already own this).
4. Install New NovaBridge (I would need to purchase this).
5. Install recommended libraries for older software (can't remember names, in the install guide...

Should that work? That should get me 100% current?

Thanks!

-Eric

It posted my message twice.. so changing this one…

Thanks for posting!

These are great! I had such a great time. Hope to see you there again soon!

-Eric “Slygon”

@sadirux

Thanks!

What I am wondering is if I can skip all the Enhancer upgrade installs, and just go right to 2.2.. so skipping the enhancer 1.5, 2.0,2.1 installs (I am guessing I will still need the graphics upgrade and the SI W3D install.. not sure..) but basically going something like:

OS 4.1 X5000 install
OS 4.1 Update 2 (I think I have a patched copy that doesn't need the hot fix).
Enhancer 2.2.

(Then maybe the other graphics updates....)

I just don't know if that would work....

@amigakit

I have Enhancer 2.0 installed, I believe I can download the upgrade. Is the upgrade download a full version?

Per similar comments, I would like to download the update, save it off, and do a clean install of my X5000. Will the version that downloads work for a clean install?

Thanks a ton! Great work!

-Eric

Looks great Walkero!

Thank you!

-Slygon

@Tuskagee

I just installed the update on a completely clean install of my X5000. And yes... Mounter is dead...

Did you figure out a solution/fix for this?

Thanks!

-Slygon