Forums - All Posts - The Amigans website

Forum Index

Board index » All Posts (davec555)

Bottom

« 1 2 (3)

davec555

Re: AmigaOS port of libsmb2

Posted on: 2023/1/12 1:28 #41

Just popping in

So what I did, was go in to Devs/DosDrivers and duplicated IDF0 and renamed to the name I wanted the share to appear as.
I then edited the file to remove what was there and added the info specified in the Readme for smb2fs, with the Startup entry reading:
Startup = "smb://<yourusername>:<yourp ... are>/<sharename> VOLUME=<nameofshareonamiga>"

as far as I know, I only have smb2fs installed and running (ie, no old versions)

Dave

@RazielQuote:

Raziel wrote:@all

Can someone give me a quick rundown on what to do before using libsmb2, please?

The readme says to use my share like this:
smb://[<domain;][[:]()][:]//

I don't have a smb: set up right now

...and can't I just use my ip address as with smbfs (which I'm using)?

Thank you

Topic | Forum

davec555

Re: AmigaOS port of libsmb2

Posted on: 2023/1/12 1:20 #42

Just popping in

Based on this info, I leave ACTIVATE=0 set, but add the following line to s:Network-Startup and the drive icons now appear on WB automatically on boot.

DiskChange <mountname:>

...replacing <mountname:> with the appropriately assigned mountname. I replicate that line for each share I want to mount.

Dave

@nbacheQuote:

nbache wrote:The sensible way of mounting a network share is to do it from Network-Startup after the AddNetInterface line. I do that (with the old SMBFS and SMBMounter) by first having a line with "Wait 5 secs", then "GetNetStatus CHECK INTERFACES,RESOLVER,DEFAULTROUTE". This is not necessarily 100%, but works for me almost always. If WARN, I quit with a warning requester. Otherwise I move on to whatever I want to do with the network (e.g. fetching time via NTP). For the SMB share, I have this section:

CD
WBRun SMBMounter
CD SYS:

(I could also have used PCD, but since I know my current dir was SYS: at the start, I simplified it.)

SMBMounter is of course configured to automount whichever share I want up at startup.

Edit: BTW, can SMBMounter be used with the new SMB2?

Best regards,

Niels

Topic | Forum

davec555

Re: AmigaOS port of libsmb2

Posted on: 2023/1/9 20:12 #43

Just popping in

I too have this problem. Does Active=1 work for anyone?

thanks
Dave

@trgsweQuote:

trgswe wrote:@salass00

... i have the active=1 in the tooltypes but when booting the
samba share isn't mounted and can't be mounted either

Topic | Forum

Top

« 1 2 (3)