Login
Username:

Password:

Remember me



Lost Password?

Register now!

Sections

Who's Online
126 user(s) are online (75 user(s) are browsing Forums)

Members: 1
Guests: 125

nbache, more...

Headlines

 
  Register To Post  

X5000 not booting
Just popping in
Just popping in


See User information
Well my X5000 seems to have given up the ghost. I have written before about strange gremlins. I turned it off the other day as the case fan was rattling so needed a change out.

Changed fan booted fine started messing with it and it locked up. Hmmm... rebooted locked up again. Rebooted nothing. Hard power down. Nothing..

Debug output is...

U-Boot aeon-2020-08-09 (Aug 09 2020 02:21:37)

CPU0:  P5020Version2.0, (0x82200020)
Core:  e5500Version1.2, (0x80240012)
Clock Configuration:
       
CPU0:1995 MHzCPU1:1995 MHz,
       
CCB:798  MHz,
       
DDR:665  MHz (1330 MT/s data rate) (Asynchronous), LBC:49.875 MHz
       FMAN1
498.750 MHz
       QMAN
:  399 MHz
       PME
:   399 MHz
L1
:    D-cache 32 KiB enabled
       I
-cache 32 KiB enabled
Reset Configuration Word 
(RCW):
       
000000000c540000 00000000 1e1e0000 00000000
       00000010
44808c00 ff002000 68000000 45000000
       00000020
00000000 00000000 00000000 0003000f
       00000030
a0000000 00000000 00000000 00000000
Board
CYRUS
36
-bit Addressing
I2C
:   ready
SPI
:   ready
DRAM
:  Initializing....using SPD
Detected UDIMM KHX1600C10D3
/4G
Detected UDIMM KHX1600C10D3
/4G
Not enough bank
(chip-select) for CS0+CS1 on controller 0interleaving disabled!
Not enough bank(chip-select) for CS0+CS1 on controller 1interleaving disabled!
Waiting for D_INIT timeoutMemory may not work.
6 GiB left unmapped
8 GiB 
(DDR364-bitCL=9ECC off)
       
DDR Controller Interleaving Modecache line


I am pretty bummed at this point...

Doug

Go to top
Re: X5000 not booting
Home away from home
Home away from home


See User information
@DStastny

Serial says memory error.

I'd try to remove both memory sticks and put them back in, one, than the other, and see if one of them were bricked (hopefully not both)

People are dying.
Entire ecosystems are collapsing.
We are in the beginning of a mass extinction.
And all you can talk about is money and fairytales of eternal economic growth.
How dare you!
– Greta Thunberg
Go to top
Re: X5000 not booting
Just can't stay away
Just can't stay away


See User information
X1000 says insufficient RAM sometimes if a SATA lead is bad/loose. Try reseating them. Also replace your CMOS battery, A-Ones are notorious for being flakey with bad batteries.

AmigaOne X1000.
Radeon RX550

http://www.tinylife.org.uk/
Go to top
Re: X5000 not booting
Not too shy to talk
Not too shy to talk


See User information
@DStastny

Are you using a beta UBoot ?

U-Boot aeon-2020-08-09 (Aug 09 2020 - 02:21:37)

Sinan - AmigaOS4 Beta-Tester
- AmigaOne X5000
- AmigaOne A1222
- Sam460ex
Go to top
Re: X5000 not booting
Not too shy to talk
Not too shy to talk


See User information
@DStastny

I had the exact same issue. It wasnothing to do with the RAM (mine says the same as yours), its to do with what the Bios is doing next.

It will either be a power issue (PSU 12v ATX connector not plugged in correctly) or more likely the CR2032 battery (if charged) is not 100% in the correct place.


Go to top
Re: X5000 not booting
Just popping in
Just popping in


See User information
@derfs

I think you are on to something with the battery, as I had previous post about clock not working. I had done a test to find that with hard power offs the clock just resets so clearly that battery is dead. My understanding though is the battery should not be required to boot as time is just set as part of startup over the net.

But I will try replacing the battery on my way home pick up new one. I was excited for the quiet with the new fan. The is definitely finicky hardware. Seems lots of reports now after a few years in wild X5000 exhibit strange booting problems. Be nice if we can document all the weird causes.

Ill fill in thread if I get her up and running.

Thanks
Doug

Go to top
Re: X5000 not booting
Just popping in
Just popping in


See User information
@Thread

Thanks for inputs, she is booting and running again.

So...
@Derf - replaced battery no joy.

@Raziel - memory is lottery winner, I pulled the sticks and reseated one and it boots. Not sure if it is really memory or something else. For now just leaving one stick in as I don't want to look at it funny 😂

@All
The RTC does not work at all. After booting successfully tried some tests. Powered down power supply and board reboot date-time resets. Set the date with our friend Date and Setclock Save power down machine but don't power down supply the board time is saved in RTC life is good. If machine is unplugged no joy.

So the battery is just not running the clock. I will be honest I am not sure it ever has worked correctly, with my numerous posts about date/time issues. I can live with that as I use net time to sync on boot.

I do really appreciate this forum for all of you who chime in to always help with no toxicity that I see in other Amiga forums!

Regards
Doug

Go to top
Re: X5000 not booting
Not too shy to talk
Not too shy to talk


See User information
@DStastny

Yeah would bet on the battery, had that happened to me once on my XE.
If not, SATA cables is the next suspect, got myself SATA cables with locking clips when I built my X5000.

Hope you find the problem and everything works out ok.

Edit Sorry missed your reply above, great to hear that she's booting up again!


Edited by khayoz on 2021/1/29 23:30:29
1989-> A500, A600, A3000, A4000, A1200, CD32, µA1, PegII, A1XE, CDTV, Amy/416D79, A1X5000, Vampire 500 V2+, Vampire 600 V2, Amy-ITX, Denise ITX <-2024
Go to top
Re: X5000 not booting
Home away from home
Home away from home


See User information
@DStastny

Resized Image

I only hope that there is no hardware bug on the second ram bank...maybe its "just" the other ram stick.

Anyway, I had and still have problems with interweaving between ram sticks when using more than two sticks on the nemo.
Seems that was never properly tested and the firmware lacks proper support.

People are dying.
Entire ecosystems are collapsing.
We are in the beginning of a mass extinction.
And all you can talk about is money and fairytales of eternal economic growth.
How dare you!
– Greta Thunberg
Go to top

  Register To Post

 




Currently Active Users Viewing This Thread: 1 ( 0 members and 1 Anonymous Users )




Powered by XOOPS 2.0 © 2001-2023 The XOOPS Project