klapdeur wrote:
Hi guys im looking for a gfx board for a amiga 4000 .

one that works with picasso or cgx.

if you have one on sale just let me know at <SNIP - edited out email address>

regards
klapdeur

ChrisH wrote:
@Tajmaster
Why do you want a RadeonHD card anyway? The Sam440's Radeon 9250 (built-in or otherwise) is pretty good, and actually has working 3D!

If you have a non-Flex Sam440 (I forget) then it only has 64MB of Graphics RAM, which can be a little limiting (and cause massive slow-down in the worst case), but with a little tweaking to settings it should be fine (IMHO).

ChrisH wrote:
@Tajmaster
As there has been no mention of these drivers working on Sam440, I think best to assume it won't work (until we are told otherwise). However, if you are feeling rich, then feel free to take a chance that it will somehow work!

tommysammy wrote:
Releasedate is Q3/2012

eliyahu wrote:
@Tajmaster

yeah, it's brutally slow on my SAM as well. the friedens did mention it would be poky -- but, yeah, i wouldn't call it usable on our SAMs. on the plus side progress has been made, and it does seem much more complete than the previous release. i reckon us poor-ol' SAM folk will need to wait for future releases before we can hop on the timberwolf train.

by the way, at least on my SAM, the entire system seems to slow to a crawl when timberwolf is running. i'm not running out of memory or forcing active swapping, so i wonder if there is some while loop spinning somewhere eating up all of the available CPU cycles.

-- eliyahu